What is use of engine kill switch?

The kill switch or emergency switch or engine shut off/cut off (switch) (even the naming is ambiguous) is a red switch located on the right handle bar of just about every modern motorcycle commercially manufactured today. It is a safety feature that can be used to cut power to the engine in the event of an emergency.

What is kill switch in scooter?

Usually Kill Switch helps in Stop/Go Traffic or short halts which saves your fuel without spending time to repeatedly switching ignition ON/OFF by key. Its close to throttle so its easy to turn engine ON/OFF without ON/OFF the electricals of the scooter.

How do you turn off a motorcycle?

Starts here1:25How to Turn on & Shut Off a Motorcycle | Motorcycle RidingYouTubeStart of suggested clipEnd of suggested clip46 second suggested clipAnd has a choke. You will have to turn that on as well. Pull in the clutch as many motorcycles haveMoreAnd has a choke. You will have to turn that on as well. Pull in the clutch as many motorcycles have safety fail-safes and then thumb the black starter. Button.

How does a kill switch work on motorcycle?

A kill switch is wired to the ignition coil (the part of the motorcycle that sends a spark through a spark plug wire to the spark plug and sparks the engine). The switch breaks the ground circuit in the ignition coil so that the coil no longer has a positive and a ground.

Where is the engine cut-off switch on a motorcycle?

The engine cut-off switch is typically located near the right handgrip. Be sure to familiarize yourself with the mechanics of a motorcycle before riding it for the first time.

Where is the engine cut off switch on a motorcycle?

What happens if you hit the Kill Switch on a motorcycle?

If the bike is running and you hit the kill switch, it goes dead. And if the bike is moving down the road, it also goes dead and coasts to a stop. Put the kill switch back on while it’s rolling, the bike will restart (assuming you haven’t let out the clutch), and you may get a backfire. This will not damage the bike.

What is the purpose of a Kill Switch?

The purpose of a kill switch is to simply switch off the engine by cutting off the engine ignition. When you insert the key in the ignition switch, the current from the ignition switch is fed to the kill switch and then passed to the fuel pump relays and engine control relay.The engine’s ignition will be turned ON only when the circuit is complete.

How often do you use engine kill switch at traffic lights?

There is absolutely no harm in using engine kill switch at traffic lights or as frequently as you desire. I’m using it from last 4 years to turn off the bike every time at signal or similar case. Case 1. If you’re going to restart your bike after switching it off (say at a signal), then use the engine kill switch.

Should I use the engine kill switch or ignition key?

If you’re going to restart your bike after switching it off (say at a signal), then use the engine kill switch. Case 2. If you’re not going to start the bike again for sometime (say while parking it), then switch off the bike using the ignition key.

https://www.youtube.com/watch?v=vg-6Yg4u-4k