What is the proper procedure for soldering and desoldering?

Clean the tip of the hot soldering iron on a damp sponge. Many people then add a tiny amount of fresh solder to the cleansed tip. Heat all parts of the joint with the iron for under a second or so. Continue heating, then apply sufficient solder only, to form an adequate joint.

What two methods are commonly used to Desolder?

Methods of Desoldering

• Using a Soldering Iron. Soldering iron is the simplest and easiest method to desolder components.
• Using a Soldering Wick. The soldering wick method is used to remove unwanted solder after the process of soldering.
• Using a Desoldering Pump.
• Using a Heat Gun.
• Using Compressed Air.

What tool is used to remove solder from the PCB?

desoldering pump
A desoldering pump, colloquially known as a solder sucker, is a manually-operated device which is used to remove solder from a printed circuit board. There are two types: the plunger style and bulb style. (An electrically-operated pump for this purpose would usually be called a vacuum pump.)

How do you solder electronic components to a printed circuit board?

What Are the Steps to PCB Soldering?

1. Prepare Your Iron. Before you can use an iron to solder, you’ll want to complete a process known tinning.
2. Prepare Your Surface. The key to a good soldering job is to start with a clean surface.
3. Place the Components.
4. Apply Some Heat.
5. Add Solder to the Joint.
6. Finish Up.

How do you remove solder without a vacuum?

Place your wick against the point where you want to remove solder, then hold your irons tip over that point. You’ll see the solder soak into the wires around the point where your iron is touching once it gets hot enough to melt.

How do you remove solder yourself?

Heat the old solder with your soldering iron. Using the tip of your soldering iron, heat the old solder until it melts. You can push the terminal with the soldering iron tip at the same time to help free the component as the old solder melts.

How to desolder components with soldering iron?

Soldering iron is the simplest and easiest method to desolder components. You do not need any other tools apart from the soldering iron and a pair of fliers. Heat the solder using the soldering iron until it starts to melt. Nudge the pins using the iron and move the solder away from the joints.

What is the best way to desolder components?

Soldering iron is the simplest and easiest method to desolder components. You do not need any other tools apart from the soldering iron and a pair of fliers. Here is what you have to do, Heat the solder using the soldering iron until it starts to melt.

How do I remove the leads from a soldering board?

Make sure to heat the connection just long enough to melt the solder. The leads were removed from the solder pads by heating the joint on the top side of the board, while pulling out the leads with a pair of tweezers. It is common for solder to cover up some of the holes through solder pads on the board.

What is desoldering in electronics?

Desoldering is the process of melting the solder and removing the joints made between two materials. In electronics, it refers to the removal of electrical components from PCB for troubleshooting, repairing, replacing, and salvaging. Desoldering is most commonly used for this purpose.