How far apart should outlets be in basement?

Electrical. The national electric code calls for outlets on walls every 12 feet, on any wall wider than 24 inches, and GFCI (ground fault current interrupter) outlets in bathrooms and above countertops. Check with your local, municipality, and state codes.

What is the minimum number of receptacles required in an unfinished basement?

5
There are 5 unfinished basement receptacle. Ground-fault circuit-interrupter protection for personnel is required for all 125-volt, single-phase, 15- and 20-ampere receptacles installed in unfinished basements.

Does every outlet in a basement need to be GFCI?

GFCI protection is required for 125-volt to 250-volt receptacles supplied by single-phase branch circuits rated 150 volts or less to the ground. GFCI receptacles are required in bathrooms, garages, crawl spaces, basements, laundry rooms and areas where a water source is present.

How many circuits should a basement have?

I’d recommend supplementing that with two or three additional 20-amp circuits. You at least need a 20-amp circuit for the bathroom. A lot of the electrical design depends on what you plan to do in the basement, and what electrical equipment will be down there.

What is code for outlets in a basement?

Standard basement electrical outlet height is 15” as per the NEC – National Electrical Code. This measurement is taken from the bottom of the receptacle box to the level of the floor below. There are no special guidelines for basement outlet height as per the NEC – they are the same height as any other floor.

Does dryer need GFCI?

First, receptacles installed to serve kitchen countertops must be GFCI protected. Therefore, clothes dryers are now required to be GFCI protected because they are in the laundry area.

How many outlets can be on a 20 amp circuit in a basement?

13 outlets
The number of outlets on a branch circuit shall not exceed 10 outlets on a 15 amp circuit and 13 outlets on a 20 amp circuit.

How high should an electrical outlet be in an unfinished basement?

The NEC has no requirements for minimum height for these outlets either, but you want to place them high enough to keep them dry. The NEC does specify a maximum height for outdoor outlets. It is 6 1/2 feet above grade. You should follow this requirement in an unfinished basement even if another outlet is within 6 feet of the one you’re installing.

What is the size of a receptacle outlet in a room?

NEC 210–52 Generally, receptacle outlets in habitable rooms shall be installed so that no point along the floor line (measured horizontally) in any wall space is more than 6 feet from an outlet in that space. An outlet shall be installed in each wall space 2 feet or more in width.

How do you wire a basement outlet without a plug?

Common Methods for Wiring Basement Outlets You do not need to run a separate wire from each outlet to the electrical circuit breaker panel. The outlets can be wired with a loop between each one, then the first or last outlet box can have the wire that runs to the electrical panel.

What is the standard height of an outlet on the wall?

This standard height is 16 to 18 inches from the center of the outlet to the floor. Also, what is the code for outlets on a wall? NEC 210–52 Generally, receptacle outlets in habitable rooms shall be installed so that no point along the floor line (measured horizontally) in any wall space is more than 6 feet from an outlet in that space.