What does a balance staff do in a watch?

The balance staff is the center shaft on the balance wheel. It has top and bottom “pivots,” or very thin points that the balance wheel rides on and that receive support from the balance jewels. The staff pivots can be broken from a drop or hard bump and are the most common problem with an old pocket watch.

How do you remove a Hairspring from a balance wheel?

To remove the hairspring from the balance slide a small thin screwdriver blade under the collet at the notch and carefully twist the screwdriver side to side until the collet is free from it’s seat.

What is the purpose of a balance wheel?

A balance wheel, or balance, is the timekeeping device used in mechanical watches and small clocks, analogous to the pendulum in a pendulum clock. It is a weighted wheel that rotates back and forth, being returned toward its center position by a spiral torsion spring, known as the balance spring or hairspring.

Why is it important to balance the needs of an Organisation and its customers?

Balance is a very important component of our lives. It is not only crucial for our life but is also important in terms of marketing. Companies need to know how to balance the expectations of customers and their needs. If they do not do this they will end up their customers unsatisfied and hence causing losses to them.

How do you balance work loads?

8 Ways to Balance Your Workload for Max Productivity

1. Write down in one place all your important goals and priorities.
2. Stop wasting the first hour of your workday.
3. Do one thing at a time—well.
4. Don’t open unimportant mail.
5. Handle each task only once and never more than twice.

What does a hairspring do?

A balance spring, or hairspring, is a spring attached to the balance wheel in mechanical timepieces. It causes the balance wheel to oscillate with a resonant frequency when the timepiece is running, which controls the speed at which the wheels of the timepiece turn, thus the rate of movement of the hands.

How are watch Hairsprings made?

The hairspring begins with the raw Nivarox alloy which Lange buys from a supplier (below). This wire is 0.5 mm in diameter. It is then draw through a series of dies, stretching it out and reducing its diameter. This is done repeatedly until the wire is a mere 0.046 mm in diameter.

Is wheel balancing necessary?

Wheel balancing is important because wheels lose their balance over time. Factors concerning the weight distribution of your vehicle, road conditions and tread wear can cause an unevenness in the tires, which can then lead to further uneven tread wear. As a result, the vehicle might shake or vibrate while in use.

Why is it important to replace the balance staff in watches?

Correct replacement of the balance staff in a mechanical watch is of the utmost importance. If the staff is not properly installed, a good watch will become a poor timekeeper. When the balance staff is correctly installed, the balance wheel will run true and level with relationship to the axis of the pivots on the balance staff.

What are the parts of the balance of a watch?

This particular watch uses the rivet type of staff that is staked onto the balance wheel. These are the component parts of the balance. The balance wheel with staff, hairspring, roller table and balance bridge. Broken Staff. This shows the broken pivot of the staff. It is at the bottom.

Why is it important to replace the balance staff in mechanical?

Correct replacement of the balance staff in a mechanical watch is of the utmost importance. If the staff is not properly installed, a good watch will become a poor timekeeper. When the balance staff is correctly installed, the balance wheel will run true and level with relationship to the axis of the pivots on the balance staff.

Can you replace the staff on a vintage watch?

Replacing the staff preserves the watch’s originality. For most vintage watches up until the 1950s, balance wheels are numbered. A watch with matched numbers on the balance and bridges will fetch more money when sold. Swapping rarely works because the parts aren’t truly interchangeable.